3 Installing Device

This chapter introduces how to install the device.

3.1 Embedded Installation

ED-HMI3630-101C device supports embedded front installation, which is equipped with a Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws).

Preparation：

  • A Mounting Kit (including 4 x buckles, 4xM4*10 screws and 4xM4*16 screws) have been obtained from the packaging box.

  • A cross screwdriver has been prepared.

Steps：

  1. Ensure the opening size of the cabinet according to the size of ED-HMI3630-101C, as shown in the figure below.

    image-20240812151235252

  2. Drill a hole on the cabinet according to the hole size of step1.

  3. Insert the ED-HMI3630-101C into the cabinet from the outside.

    hmi3630-101c-install

  4. Align the screw hole (unthreaded hole) of the buckle with the buckle installation hole on the device.

    image-20240812152033085

  5. Use 4xM4*10 screws to pass through the buckle and tighten it clockwise to fix the buckle to the device; then use 4xM4*16 screws to pass through the screw hole (threaded hole) of the buckle and tighten clockwise to the end through the buckles.

image